The Echo Bouvier Message Forum  

Go Back   The Echo Bouvier Message Forum > All Breeds > Dog Arts and Crafts

Reply
 
Thread Tools Display Modes
  #1  
Old 11-14-2010, 01:41 PM
Mike Mike is offline
Administrator
Site Admin
 
Join Date: Aug 2004
Location: Hillsboro, OR
Posts: 169
Default More Glass Paw Print Coasters and Bouv Profiles

I finally got around to finishing the last 2 paw coasters I started, this time I did them in a red base. I've always thought red and black went well together although I was afraid the red glass I used wasn't going to be red enough. I was glad to see that after it was fired it turned a bit redder than it was un-fired.

I also finished the Bouvier profiles I had cut out over the last couple of weeks. I was waiting on some dimonad bits and then I had to find a chuck reducer for my drill since the smallest bit I wanted to use was to small for my drill chuck to hold on to. I finally found a smaller collet for my Drimmel, although I don't like the Drimmel as much as my drill as the drill is variable speed and I can go slow. The Drimmel, even on it's lowest speed is still way to fast for me. But I got them drilled. The biggest profile has two holes drilled and the others only have one. The last two I did I decided to leave a little tab on the back and that is where I drilled my hole.

The red paws:



And the Bouv profiles:



Mike
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -12. The time now is 01:47 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.