Bouvier Profile Cut From Stainless Steel

[Mike]

This is a couple of the 5 Bouvier profile that I had cut out of a sheet of stainless steel by waterjet. I wanted to see how well the image I'd created cut out before I did it in the glass that I show in the next thread. They are still in a raw state as I've not polished these yet.



I'm not sure what I'm going to do with them but have been thinking of power coating them in black and making big fridge magnets, paper weights or hot plates out of them.

Mike

[Mike]

This is the 3 sizes I had cut from glass using the same image file that I used for the stainless steel:



These are the way they look cut out of the raw glass. Once I fuse them they will get shiny and have rounded smooth edges.

Mike